Causes of Surface Cracks in High-Speed Wire Rod Rolling Mill Crack refers to the defect that the surface of the wire rod is straight or bent, Doblado o penetrado en el interior del alambrón en un cierto ángulo a lo largo de la dirección de rodamiento.. Crack length and depth are different and […]
Causas de las grietas superficiales en el laminador de alambrón Sigue leyendo »
Hay cuatro tipos básicos de laminadores en caliente de aluminio.: bobinado simple de soporte único, bobinado doble de soporte simple, “1 + 1” double stand double coiling, Laminación de desbaste en caliente + laminado continuo de acabado en caliente. The configuration of the latter is “1 + 3”, “1 + 4” o “1 + 5”, y
Laminador en caliente de aluminio Sigue leyendo »
Billet Selection and Heating of 0.8MTA Hot Rolled Wire Rod Mill Production Line In this Hot Rolled Wire Rod Mill production line because of the close distance between the continuous casting machine and rolling line, the hot billet is used as raw material and hot charging process of continuous casting
Selección de palanquilla y calentamiento del molino de alambrón laminado en caliente Sigue leyendo »
Finishing mill is the most important and key equipment in high-speed wire rod mill production line. The technical performance of finishing mill marks the equipment level of high-speed wire rod mill production line. It is very important for the quality of finished products and the smooth commissioning and production of
Características principales del molino de acabado Sigue leyendo »
Reasons for Mill Roll Cracks Owing to the high wear resistance and minimal plastic deformation of the cold mill roll, it is required that the surface of the cold mill roll have higher hardness and thicker hardening layer. The material of cold roll is 9Cr2Mo. The surface hardness of HS96
Failure Analysis of Cold Mill Roll Sigue leyendo »
